A-A-50110
March 31, 1987
COMMERCIAL ITEM DESCRIPTION
RACK, BREAD, BAKER’S: 10-SHELF, KNOCKDOWN TYPE
The General Services Administration has authorized the use of this commercial item description in preference to MIL-R-2345.
1. DESCRIPTION.
This commercial item description covers mobile, knockdown type, bread racks having 10 removable shelves and open sides and ends.
2. SALIENT CHARACTERISTICS.
2.1 Design and construction. Bread racks shall be fabricated from either stainless steel, aluminum, or carbon steel. The racks shall be dip galvanized to a minimum thickness of 0.0001 inch. The rack shown ni figure 1, except for specified dimensions, is for illustrative purposes only and is not intended to exclude racks otherwise meeting all of the requirements of this commercial item description. Rack length, width, height, number of shelves, and clearance between shelves shall be as shown in figure 1. The rack shall be of the knockdown type and shall be furnished with complete instructions for assembly of the components. The rack shall be mounted on four casters. The rack shall be designed to hold a 1000-pound load equally distributed over the ten shelves without any evidence of failure or permanent deformation. The rack shall also be capable of being loaded with 800 pounds (the weight being equally divided and uniformly distributed over the ten shelves) and then rolled over a 1/8 inch obstacle without any damage. If necessary, the racks shall be properly reinforced and casters shall be firmly assembled to a steel plate or plates and welded to the underside of the racks, in order to comply with all the requirements and tests.
2.2 Casters. Casters shall be 5 inches in diameter, swivel, and have a minimum load rating of 375 pounds for each caster. Two of the four casters shall be provided with locking brakes.
2.3 Shelves. The shelves shall consist of a frame and supporting wires. The supporting wires shall be spaced 1 inch + 1/4 inch on centers, and shall be welded or otherwise securely fastened to the frame. Shelves shall not be less than 27-3/4 inches wide or less than 65-3/4 inches long. Shelves shall not protrude beyond the rack frames.
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business